Differences

This shows you the differences between two versions of the page.

--- how_to_run_a_simulation [2015/02/19 12:13]
j.parisi
+++ how_to_run_a_simulation [2017/05/12 06:55] (current)
y.audouin [How to run a simulation?]
@@ Line 16: / Line 16: @@
 {{:runningTestCase.png}}
+==== Deadlock on execution ====
+If when you are testing a case the listing seems block just after displaying the header.
+It might be because your mpi installation is not registered to do that.
+Do the following actions:
+  - In an admnistrator shell type the following commands:
+  - smpd -install
+  - mpiexec -remove
+  - mpiexec -register (With your windows login)
+If you do not have administrator rights.
+A temporary solution that you will have to redo everytime you open a new shell.
+Is to go inside the temporary folder run the command that was displayed in the listing (the one with mpirun in it).
+To check that it worked:
+  - In an user shell type the following commands
+  - mpiexec -validate (it should return SUCCESS on a user shell)
+  - smpd -status (it should return 'smpd running on <hostname>')