How to run a simulation?

After installing the TELEMAC system with the automatic installer, the software can be run through the shortcut created during the installation process.

Running a test case

All test cases are in C:\opentelemac-mascaret\v7p0\examples

  1. Double click on the TELEMAC v7p0 shortcut
  2. Navigate to the test case folder. For example C:\opentelemac-mascaret\v7p0\examples\telemac2d\bumpflu
    cd examples\telemac2d\bumpflu

  3. Run the following command: t2d_bumpflu.cas

Deadlock on execution

If when you are testing a case the listing seems block just after displaying the header. It might be because your mpi installation is not registered to do that.

Do the following actions:

  1. In an admnistrator shell type the following commands:
  2. smpd -install
  3. mpiexec -remove
  4. mpiexec -register (With your windows login)

If you do not have administrator rights. A temporary solution that you will have to redo everytime you open a new shell. Is to go inside the temporary folder run the command that was displayed in the listing (the one with mpirun in it).

To check that it worked:

  1. In an user shell type the following commands
  2. mpiexec -validate (it should return SUCCESS on a user shell)
  3. smpd -status (it should return 'smpd running on <hostname>')
how_to_run_a_simulation.txt · Last modified: 2017/05/12 07:55 by y.audouin